3M EPS300 Adhesive lined heat shrink tubing

3M EPS-300 3 to 1 Adhesive Lined Heat Shrinkable Tubing

Features:

  • 3:1 Shrink Ratio with melt adhesive inner lining (shrinks to 1/3 its original diameter)
  • Up to 15% longitudinal shrinkage
  • Meets requirements of AMS-DTL-23053/4 (formerly MIL-I-23053/4), Class 3
  • UL 224 VW-1 and CSA OFT recognized
  • Maximum use temperature 135°C
  • Shrink Temperature of 90°C and operating temperature of -55°C to + 110°C
  • Crosses to : Sumitomo W3B2, Raychem ATUM, Alpha FIT-321, 3M EPS-300, Canusa CPA-100 , LG GSHS-3635W
  • Typical applications include: Insulation, Wire Identification, Wire Bundling, Mechanical Protection, Color Coding, Lightweight Harnessing, Physical/Electrical Protection of Components, Strain Relief, and Solder Insulation.


Diameter Piece Buy
1/8" 4 FT/PIECE
$4.00 HS-EPS300-0125
3/16" 4 FT/PIECE
$4.25 HS-EPS300-0188
1/4" 4 FT/PIECE
$5.20 HS-EPS300-025
3/8" 4 FT/PIECE
$6.00 HS-EPS300-0375
1/2" 4 FT/PIECE
$7.00 HS-EPS300-050
3/4" 4 FT/PIECE
$12.00 HS-EPS300-075
1" 4 FT/PIECE
$14.00 HS-EPS300-100
1-1/2" 4 FT/PIECE
$24.00 HS-EPS300-150

3M EPS-300 3:1 Dual Wall Heat Shrink Tubing

Our 3:1 heat shrink tubing is also available with a "dual-wall" construction. When exposed to heat (usually a bit lower than the activation temperature of the heat shrink), the inner layer begins to flow (just like a hot melt glue). When the tubing shrinks and cools down, inner layer forms an adhesion layer between the tubing and the component or wire. This provides a water-tight seal, protecting the connector and/or wire.
AMS-DTL-23053/4-Size  
  Nominal Before Shrinking After shrinking
301 1/8" 0.120" .040"
N/A 3/16" 0.180" .060"
302 1/4" 0.240" .080"
N/A 3/8" 0.360" .120"
303 1/2" 0.470" .160"
N/A 3/4" 0.750" .250"
304 1" 0.940" .320"
305 1 ½" 1.570" .440"
Write Your Own Review
You're reviewing:3M EPS300 Adhesive lined heat shrink tubing
Your Rating